Yong Rui visit customers according to records, summed up to customer problems is finished burrs problems squeezing pressure ball machine, through the guidance of our technicians, is able to adjust into the normal production process. Pressure the ball burrs all because of a ball on the bit biased. burrs and difficult to be able to solve the problem of stripping after adjusting the position of the bearing. in the end how much to adjust the fit should be adjusted according to the finished product. The gap between the two rollers skin not be too large nor too small. The gap is too large finished stripping difficult, there are flash, the dregs. There are defects on the bit uneven, but also re-done in accordance with the production process, which is the owner of the most annoying thing, time-consuming, to no avail. The gap is too small will lock both roll skin, ranging from reduced life pressure ball machine, heavy damage to the roller, causing the device can not operate normally, re-exchange of the rolls. Over and are wrong, you can not go to extremes. We all know that this is an important piece, so to follow standard operating procedures to use the equipment. Timely maintenance and repair equipment.